Phase 1 Testing Complete
After a bit of work, I got the PI 5 to boot off the headers with no warnings. That was a big relief. Now I can order the remaining supplies and put the rack together. A couple of settings in the config.txt were needed.
usb_max_current_enable=1
PSU_MAX_CURRENT=5000Rebooted and everything ran fine. I tested the voltage using the following:
pin 2 + pin 6
pin 2 + pin 14
pin 4 + pin 6
pin 4 + pin 14
all of them measured in at + or – .01 volts of being 5 volts. So happy.
Here is Pi 5 with the breakout board on the gpio headers.
Here is the fuse box I will be using.
Here is the Mean Well 350-5 Power Supply I will be using.
